[Dynik]

Hey guys… I have a little problem with my bike. i took a nasty fall couple weeks ago but didn’t damage my bike to bad. My bike started up fine in my garage after I replaced a clutch cover. Then I had to replace my fairings so I took of all the plastics including the front with the gage and the ignition key. Now when I put it all together the bike wont start. When I would turn the key, the gages start up fine, but you can’t hear the fuel pump… it’s almost like the kill switch is on (but it’s not). When I press the start button the started is turning but it’s almost like there is not fuel going into the engine. It’s probably something minor…. Anybody have any ideas?
thanks

[leelover]

Not sure on this bike but the 1000's have a tip over sensor in the front fairing. If it is not aligned properly it could be your problem.

[Dynik]

Originally Posted by leelover

Not sure on this bike but the 1000's have a tip over sensor in the front fairing. If it is not aligned properly it could be your problem.

That’s exactly what it was… I had it upsidedown… Doh! It working fine now… Thanks a million

[leelover]

Great!
Glad you got her goin'!