installing race bodywork

chrome420 · 05-04-2008, 10:34 PM

I'm setting up my 02 F4i for the track. When I removed my stock lights and bodywork I noticed the bank angle sensor is mounted in between the headlights.

Is there any good way to relocate the sensor and separate the wiring from the headlights?

Thanks

ReDevil · 05-05-2008, 12:09 AM

I generally plug the wires of the headlight and use the whole front wiring loom when I put me race fairings on. As I am using my factory fairings for track days, I just bolt it back in place but I have seen guys using a cable tie to place it to the same location on the front. I think you should be careful where you place it as too low and it may cut of the engine into a corner.
Rather than seperating the wiring for the headlight from the sensor, I reckon you look for a spare at the wreckers. I see them around for $50-60 at Vic Motorcycle wreck.

chrome420 · 05-05-2008, 9:59 AM

Sounds good. Thanks for the help.

cvc14 · 05-09-2008, 1:47 PM

I zip tie mine to the fairing stay just about the same spot it is on the headlight. 5+ track days liek this and its been fine.

JavyDay · 05-09-2008, 6:50 PM

Quote:

Originally Posted by cvc14

I zip tie mine to the fairing stay just about the same spot it is on the headlight. 5+ track days liek this and its been fine.

+1. I have a 600RR and used zip ties. No problem.