[83interceptor75]

hey, looking for some help.

I just changed my front and rear sprockets and chain. To get to the front/drive sprocket I had to remove the slave cylinder which is bolted to the sprocket cover. After switching it out and putting the new one in, we bolted everythting back on fired her up only to find the clutch lever had no resistence. We've leaked no fluid anywhere and even tried bleeding it. I have no idea why the clutch won't work...any ideas??? HELP!!!

Drew

[83interceptor75]

btw...even if you aren't sure but wanna throw an idea out go for it...I'm at a complete loss of what it could be...give me something to try.

thanks,

drew

[Cato85]

if the slave cylinder was ever in a non-vertical position(installed position) you will get this issue. bleed bleed and bleed again also make sure you rubber seal at the reservoir is still good or if the cap is bent. hose getting twisted will also do this those stupid stock hoses are really cheap where the rubber meets the metal at the connections.

[rokitt51]

Same thing happened with my RC, you just gotta keep bleedin.