[blade1]

i was disconnecting the cable that opens the second exhaust valve on my 08 blade & i stupidly had the servo motor disconnected when i started the bike all i had to do was remove the cable from the motor & all would have been ok but now my fault light is on all the time when i am driving. the bike is running perfect & sounds much better (like a blade should ) can anybody help me to turn off the fault light please thanks guys

[jokke1747]

1. Remove the seat .
2. Turn the ignition switch OFF.
3. Make sure the engine stop switch is turned to " http://www.fireblades.org/forums/../...L00006-296.JPG ".
   Remove the dummy connector and short the Brown and Green wire terminals of the DLC using the special tool.
   
   Connection:
   Brown - Green
   TOOL:
   SCS connector
   070PZ-ZY30100
4. Turn the ignition switch ON.
5. Remove the special tool from the DLC.
6. The MIL will light for approximately 5 seconds. While the MIL lights, short the DLC terminals again with the special tool. The self-diagnostic memory is erased if the malfunction indicator goes off and starts blinking.
   NOTE:
   • The DLC must be jumped while the MIL lights. If not, the MIL will not start blinking.
   • Note that the self-diagnostic memory cannot be erased if the ignition switch is turned OFF before the MIL starts blinking.

http://www.fireblades.org/forums/../...L00006-295.JPG comes from the dealersite so this can definitly be trusted
i dont really think you will be able to reset it because when the fi keeps lit, it means that the problem is still there...