Help!!!!! After new exaust and PC i have FI light on and red malfuction

tony42692001 · 07-11-2008, 2:37 PM

I own a 2001 Honda 929RR. I put full Micron Serpent exaust on and a Power Commander. Ran fine with the PC but when I took the stock exhaust off and put the new full on I get a red blinking light and the FI is light up. Please help me.Bike starts and runs good but the light is blinking and bothering me.

LoopyLee · 07-12-2008, 1:11 PM

to the site... Nice to see another female rider on here

HondaGalToo · 07-12-2008, 2:14 PM

When you removed the stock exhaust, you had to remove the cables that attach to the HTEV. Did you remove them from the silverish colored servo motor that is on the left side of the bike, in the area under the seat, therefore leaving the cables attached to the now removed exhaust? When removing the cables, it's necessary to turn the servo motor to get them off. The servo motor needs to be moved back to the original position. When I did mine, I marked it. All you need to do is turn it a bit until you find the position that turns off the FI light. If you removed the servo motor, you're going to need to put it back on. There's no way to "trick" the bike into thinking it's still there if it's been removed.

Welcome!

Twincam · 07-12-2008, 2:43 PM

Honda Gal is right!