[mdtoney]

I'm working on a project bike and need to pull the stem out of a 929 lower triple and replace it with a 919 stem.

The 919 stem pressed out of the 919 lower triple without issue, but the 929 stem won't budge. We tried heating the bottom of the stem/triple area with a torch and were using a 12-ton press, but no luck.

Is there a trick to getting the 929 stem out of the triple??

Thanks,
Mike

[929ADAM]

i wish i could tell you. . . try the streetfighter section peeps, cuz front end swaps are common amongst fighters