Wanted: 929/954 front end

MisterMohawk · 09-11-2006, 5:46 PM

I'd like a complete front end: forks, triples, axle and calipers if possible.

rogerjt · 09-11-2006, 8:52 PM

look on ebay. I just bought one with wheel and all for $550 shipped. Shop around. You'll find one..

slanger · 09-12-2006, 11:24 AM

why you looking for a new front end... if your replacing it all, think about a 1Krr front end with the radial mount brakes... just need to get a radial m/c

Proto · 09-12-2006, 12:10 PM

VFR750 to RC45 lookalikee ?

MisterMohawk · 09-12-2006, 8:33 PM

I recently had a low-side on my Superhawk and the front end was wrecked when the bike slid tire-first into a retaining wall. Since I need a new front end and the Shawk's suspension is notoriously shoddy I thought I'd upgrade. 929/954's are probably cheaper than an RR, so the decision is partially financially influenced.

slanger · 09-12-2006, 10:21 PM

the costs should be about the same... you can use the same rim as 929/954/1Krr with no problem, plus you would get radial mount brakes, anyway just a thought... if your going to be a bear be a grizzly right

KC-10ENG · 03-07-2007, 11:47 PM

There is a lot of swaps going on over at Honda SuperHawk right now. I am doing a hybrid with RC-51 fork legs,brakes, master cylinder 929/954 triples, and a 929 front wheel with RC wheel bearings. I will probabluy go with some Heli bars to finish it all off. The RC forks legs are also about the same length as the VTR.

Dennis

voodooridr · 03-22-2007, 8:13 PM

I've got a set of fork legs off of a 954 that I bought from someone here, I was planning on putting them on my 919 but they're too short for my swap, I also have a couple 929 lower clamp/stems if you still need anything let me know.

Dan

KC-10ENG · 03-26-2007, 9:00 PM

Hey Dan,

I need an upper and lower triple clamp for a 929/954 if you still have them. I am easier to get hold of at this email address. dennisjohnson17@hotmail.com

Dennis