CBR 900rr Rear wheel + F3 Front + rotors + Dunlop Q3's
Hey all, I come from Wristtwisters, where these wheels are common on the 919 and 599. But, thought you guys would have more interest? I don't post a lot on here (ever), but I am a moderator over there and trustworthy. Just PM for info or reply in-thread. I'm subscribed.
6 spoke 900rr Rear and F3 front, both with brand new glossy black powdercoat and a spooned on pair of Dunlop Q3's (It's a 180 in the rear, since this was going on a 599), Dynabeads included already installed. 1oz up front and 2 in the rear.
Front wheel has brand new Chinese rotors (but I tried to buy from reputable seller and the higher quality one's, not ebay knock-offs). Never been used, but seem to be high quality. I have a rear rotor that matches the front as well. Just not installed as it might be bike specific (this was to fit a CBR rear caliper, not a 919 stock caliper I believe, as that is what I was running at the time).
High quality 90 degree valve stems were installed as well. These weren't eBay knock-offs.
Front has new bearings and seals installed, rear will need bearings put in and seals as well. I left those out as I wasn't sure the rear axle size of the bike I was going to put them on.
Asking $600 for the pair. I've got more than that in them already. Tires were about $300, wheels were about $250, powdercoat was about $150 and rotors were $100+. Valve stems were $20, Dynabeads were probably $15. Plus two bearings and seals on the front tire, whatever those cost - I don't remember.
Shipping is on top of the price, since a lot of that depends on where you live.
These wheels are MINT. No scratches that I can see. Never been installed - fresh powdercoat. Front is plug-n-play, rear just needs bearing/seal/sprocket mounted and it's ready.