bridge the terminals of the service check connector
Not great on electrics so this is a very base most likely silly question, but £10 is a lot of money if you don't have any
I'm completing the Error 35 exhaust servo removal procedure, the post says once servo delete is in place I need to clear the error code by using a bridging wire on the 'service check connector'
My question is what is a bridging wire made out of ? I have some stuff about the house like solder wire or gold coloured electric wire from a plug? Or do I use say gear wire from my mountain bike? WHAT DO I USE?
Do I just hold it against the contacts or does it need to have proper connections?