Honda Motorcycles - FireBlades.org banner

Scotts install on 929

2K views 6 replies 6 participants last post by  NinerPilot 
#1 ·
I just got a 929 mounting kit and FedEx is bringing the damper tomorrow. I'm getting both things used. The damper manual is online but I would like to know more about the mounting kit. Does anyone know where I can find the instructions online.

If not everything looks pretty self explanatory, what's the torque for the nut? I saw 85 lbs but what if the set screws don't line up. To I tighten or loosen the nut?

thanks
 
#5 ·
Duh, yeah I got it put on in about 15 minutes. I guess I should have actually looked at it before asking.

Another question though, does anyone know what size bolt holds the damper to the mounting kit? I have a couple m5 taps but the pitch didn't feel right on either of them.

thanks again
 
#6 ·
Red Rider said:
The set screws screw into a recess around the nut. Make sure you torque the nut properly and USE LOC-TITE on the setscrews, otherwise they WILL back out. Ask me how I know this....
BLUE locktite not RED. Dont ask me how I know this :eek: :crying:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top