Honda Motorcycles - FireBlades.org banner
ecm
1-11 of 11 Results
  1. General Discussion
    I was riding on a hot morning on the highway. I got caught in construction and me and the bike started cooking. The bike temp got upto 220 on a stand still also hot to the touch but 185 once I started back roll. I pull over to get gas and the bike wouldn't start back up I pushed started it so I...
    ecm
  2. Honda FireBlade
    After sorting out a 954 fuel pump not priming (it was a grounding short), I fired up the bike last week to have it running very rough - it would stall out below 3K, and was choppy above that. Checked the codes, and it's throwing off 6. Codes: 1 - MAP sensor 8 - TP sensor...
  3. Honda FireBlade
    I have just replaced the fairings and undertail on my 954. Everything works now except the Tacho. I have followed the tests in the 954 Workshop Manual and there is continuity between the yellow/green terminal at the ECM up to the dash. But the voltage on the wire is only 1.16 V and it should be...
  4. For Sale
    Have a 2002 cbr954rr motor with 34000 miles for sale make decent offer runs great shifts smooth pulls in all gears. Complete motor no airbox come with radiator or radiator separately will be sold Rear suspension and swing arm Black frame with clean title asking $500 plus shipping comes with...
  5. For Sale
    I got a cdi/ecm box for sale. Picked it up for my 98 rrw thinking my old one may be bad and it ended up being the pulse generator. So i have an extra i need to get rid of. The numbers on it are as follows MASG AC 974U 7X14. My original one is MASG FC 971U 7Y14. Ill sell either one for a...
  6. Swap Section
    I have a few extra parts for sale/trade Things i have: Full front fairing : has a crack on right side just in front of where right clipon would be. Was repaired once with glue and spot putty but opened back up when i removed the fairing. Needs to be stripped and repainted also. Is currently...
  7. General Discussion
    Before I send my ECM off to Carmo I need to try for answers one more time. I've a no spark issue and I'm pretty confident that I've got everything connected properly. The odd thing about my bike at the moment is that when I disconnect my MAP or IAT sensors or one of my injectors I get the...
  8. Wanted
    Looking for a GOOD ECU. Please let me know if you have one that you KNOW is good. If you live close to SOUTH JERSEY (08731 - Toms River area) maybe we could meet up to test it out? I'm pretty sure mine is bad, but I will not be 100% positive till I try a different one. I have PayPal. Any good...
  9. Honda FireBlade
    I'm having a problem with my 01 929rr were the FI light and sold red light comes on sometimes. I did some reading through the Manual and did the check by shorting the service check connector, I get 7 blinks with that which is for the ECT sensor. Sometimes this will cause the bike not to...
  10. Honda FireBlade
    Ok, i hate writing this because its covered everywhere but my bike is just not exactly doing the same as everyone elses. So here is the deal, one day my bike just dies on me and i get it home to the garage. after taking it apart i realize the fuel pump isnt kicking on. so i test the pump by...
  11. Honda FireBlade
    Hello, My question is, On a 01 929rr does the ECM control the fuel and the spark on this machine or does the relays control those systems (explain how this works)? Also how can you findout if the ECM unit is fried or not? When you turn the key which system acts first, The ECM or the fuel...
1-11 of 11 Results
Top