Search Results for ‘problems’

Hello everyone, hope to enjoy my time on this forum, I bought a CBR 600 f4 99 in march, I've ridden about a thousand miles on it since then. In April I was riding and had hit almost a hundred miles that day when I started noticing some problems accelerating in first gear. The bike would be...

I have a 2005 CBR1000RR (milage is around 25,000 km) and nothing happens after letting the clutch out while in gear. The bike will not move. Clutch lever has good resistance and the fluid was changed 3,500 km ago. Is this the clutch not disengaging?

I have a 96 cbr 900rr I am stumped the bike was running great until 2 weeks ago and the the sudden it stumbles and sputters out under load. I have torn it down from top to bottom. I emptied the gas cleaned the carbs, checked spark plugs checked fuel filter, checked the vacuum hose to the fuel...

I can hear a clicking/ticking noise similar to that of the engine in this attached clip although the noise is not nearly as loud. The noise increases proportionally as the throttle is opened, yet only when the bike is in gear. Could it be valve related? Or possibly exhaust related? Any help is...

I just bought a 2001 CBR600 f4i. when i first turn it over, it starts fine, but after i ride it for a bit and try to turn it back over i have to give it a little gas for it to start again. it also has a flashing oil indicator and a solid red light. is something major wrong with it?

ok here is my issue, I just recently bought a 07' cbr1000rr and have put about 1k miles on it. so right now im at just over 10k miles. When i first took the bike out it ran perfectly. Acceleration and handling was a dream. I have done general upkeep. making sure tire pressure, oil/fluid levels...

I just bought a 03 CBR 600RR a week ago with 3k miles on it, the guy barely used it at all and was mostly stored for years. Ive been riding it everyday and it felt really good, nothing wrong with it besides some marks (must have layed it down) and half of the left foot peg missing, and some...

I just got a set of r&g crash protectors for my 2000 929 blade. Foillowing instructions i undid the nearside engine bolt and put the spacer in the recess in the frame. After a while of trying to fasten the bolt, it seems that it will not work and the bolt is spinning, but I'm no longer able to...