Honda Motorcycles - FireBlades.org banner

1 - 2 of 2 Posts

·
Registered
Joined
·
263 Posts
Discussion Starter #1
This winter I need to do more extensive work on my 929 than I usually do, among other things I'll be removing the engine to have it serviced. What do I need to support the bike during disassembling? Do a rear & front stand make any sense when the forks and rear shock are going to be removed and sent to a suspension shop? I was thinking doing the transmission (bad 2nd gear) and engine head replacement (bad sparkplug thread) myself, I'm also going to check my whole wire harness for a ground problem that have annoyed me for a while. I have the front stand but not rear, I was hoping I could do without it..
 
1 - 2 of 2 Posts
Top