Honda Motorcycles - FireBlades.org banner

1 - 11 of 11 Posts

·
Premium Member
Joined
·
32,034 Posts
Any ideas on how to repair this other than a new motor? It's a 2006 honda fireblade 1000rr

Get a good welder to have a look at it.
 

·
Registered
Joined
·
328 Posts
I know the guy I use for welding stuff I can't could fix that. May have to take the engine out of the bike.
 

·
Registered
Joined
·
328 Posts
JB weld will leak eventually. I JB'd mine many times with no leaks at first then over time it looks like you own a Harley with puddles under your bike. The oil will coat the foam in the plastics and goo up the lower.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #7
That sounds realistic....better start looking at low mile motors! And I did not add that face thing on my reply
 

·
Premium Member
Joined
·
32,034 Posts
That sounds realistic....better start looking at low mile motors! And I did not add that face thing on my reply

Weld it.
 

·
Registered
Joined
·
328 Posts
Have it welded. Should be around 50-100 depending on if engine is out or not.
 

·
Registered
Joined
·
53 Posts
Jj weld and paint some sealant on the inside oil just splashes around in there.
 
1 - 11 of 11 Posts
Top