Honda Motorcycles - FireBlades.org banner

1 - 5 of 5 Posts

·
President: Team Full Chat
Joined
·
8,154 Posts
Discussion Starter #1
So a couple days ago i posted a short video in my build thread (it's currently my last post) on how my transplanted F4i gauges show 2 grand as Zero on the tacho. It does the sweep, but stops at 2K thinking it's zero. I haven't got any assistance on that issue, so now I'm starting a thread on its own. Thought SOMEONE would have some insight or suggestions for me. I don't know if it will change once the tach picks up the ignition signal because the motor is still at least a week out from being installed. Once again, the start sweep works, but zeros out at 2k. Is is broken? Can it be fixed or will I be chasing my tail?
 

·
President: Team Full Chat
Joined
·
8,154 Posts
Discussion Starter #4
Just want to say a big THANKS 89, I guess you're the only one who dared to toss out a suggestion. Glad you did. I guess it got messed up when I replaced the dial face. I removed the needle without moving the shaft position, then reinstalled it at Zero again. BINGO! Phew!, stress over. hahaha

 
1 - 5 of 5 Posts
Top