Honda Motorcycles - FireBlades.org banner
1 - 2 of 2 Posts

·
Registered
Joined
·
218 Posts
Discussion Starter · #1 ·
Hiya All


I've fitted the Refurbed Rear Shock to the CBR400!



1 question here though:

Fitting the Rear Shock - should I have greased the Spindles of the Mounting Bolts??

The Bearings were pre greased by MCT suspension. I assumed that was enough.

I didn't want to slack loads of grease anywhere near the mounting bolt threads. I Just cleaned the whole area, the bolts, and the threads, and I carefully appiled Thread lock to the Mounting bolt threads.


My neighbour says not, its the bearing that move, and thats what needed greasing.

Hope you can advise.

Cheers
Martin
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top