Honda Motorcycles - FireBlades.org banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have helped move around a lot of bikes and get access to the suspension linkage. However I have a 99 CBR 600 F4 that I need to lower and I was wondering if anyone has done this yet, if there is an easy way to tackle this. I have the myrtle beach lowering links, typical 3 hole style. i have previously used joist pulley etc. I have access to a car jack (floor style), a rear/front paddock stand, and 2 jack stands, i could try the rebar through the rear to set on the jack stands. I am more concerned about gaining access to the link, and installing my new ones. Also being able to lower the tree on this bike, i do not have a triple tree stand just a multi/paddock style stand. Any suggestions which to do first, im only planning on going 1.5inches, just the bare minimum.
 
1 - 1 of 1 Posts
Top