Honda Motorcycles - FireBlades.org banner

1 - 2 of 2 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter #1
Hi All
I have a non-US 2008 fireblade, I installed full system and had to ad oxygen sensor eliminator which I made my self with 330 ohm resistor and it worked well little over a year, one day I decided to make same one but neater, So I made it and then installed it but the engine sign gave engine-code-23 which indicates oxygen sensor problems. I finally ordered original one and installed it, but still the engine-code-light is still ON, I toke the bike to Honda-garage and after a day they told me they could not fix this issue unless the bike goes back to original state which means I need to install the OEM exhaust and the whole nine-yards, but they cannot guarantee the problem will go away, they were not sure what to do.

Just as a reminder, it is non-US version.

Can some one tell me what to do about this mess ?

Thanks in advance and cheerz
 
1 - 2 of 2 Posts
Top