Honda Motorcycles - FireBlades.org banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
70 Posts
Discussion Starter #1 (Edited)
This is a 17' x 6" 6-spoke black with gold cush drive rear wheel. Forged aluminum, made by Carrozzeria back when they were known as Hi-Point. Comes with cush drive and 41T 520 vortex sprocket and spacers for RC51. The design is very similar to the RC51 6-spoke SP1 design. The current spacers could probably be modified or new ones made to fit for other models.

$350 + shipping
 

·
Registered
Joined
·
70 Posts
Discussion Starter #3
forgive my ignorance, will this wheel fit on a 954?

I'm pretty sure a stock RC rear wheel will fit on a 954 (probably using the 954 spacers), so I'm guessing the spacers on this would need to be modified to fit other bikes as this wheel has it's own non-stock spacers. I doubt the fit would be too far off though.
 

·
Registered
Joined
·
70 Posts
Discussion Starter #4 (Edited)
Bump, $350 shipped. According to Rogue the wheels weighs almost 3lbs less than stock, 19 lbs vs 16.3 lbs. It's in almost perfect shape, I'm only selling it after picking up a set of 5Y PVM wheels.

Here's some better pictures, as you can see it's very close, but not identical to the SP1 rear wheel.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top