Honda Motorcycles - FireBlades.org banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1,204 Posts
Discussion Starter #1
Hello guys,

I'm looking for a stock set of rear sets, they don't have to look good at all they can be bent, have rash, broken pegs as long as I can use them to measure the bolt hole pattern and the dimensions.

I am planing on making a set out of Aluminum and titanium and will off course, over engineer them and spec aerospace standard tolerances just for the hell of it.

With the slow down of manufacturing we have some open time on the milling dept.

I'm going to price out materials and manufacturing time using our going shop rate, It will be interesting to See the cost to profit ratio the quality rear sets out there are getting.:hmm:
 
1 - 1 of 1 Posts
Top