Honda Motorcycles - FireBlades.org banner
1 - 2 of 2 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter · #1 ·
I've seen it mentioned a few places that it's possible to access the rod bearings through the bottom of the engine while it's still in the bike. Has anyone done this? Is it possible?

One of the 900RR engines I have has a rattle that sounds like a rod bearing, hoping that it has been caught early enough to just install new bearings. Drained the oil and found only a few small sparkles in it.
 

·
Registered
Joined
·
99 Posts
I've seen it mentioned a few places that it's possible to access the rod bearings through the bottom of the engine while it's still in the bike. Has anyone done this? Is it possible?

One of the 900RR engines I have has a rattle that sounds like a rod bearing, hoping that it has been caught early enough to just install new bearings. Drained the oil and found only a few small sparkles in it.
Not sure if it’s small block Chevy worthy! I wouldn’t chance it!! Not on a blade😅
 
1 - 2 of 2 Posts
Top