Honda Motorcycles - FireBlades.org banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Folks,

I'm looking at making myself a slip on stainless exhaust for the RR-9 blade...

I work away and don't have access to my bike at the minute to grab a few dimensions from the exhaust header, I reckon the section of pipe where the can slips on is around the 50 mm mark but was hoping that someone could confirm this?

Need the approximate angle of the bend from the header, also the distance from the header to the end of the exhaust tip and also to the securing bracket.

Basically every size :laugh:laugh:laugh

sorry for all the questions but if anyone could help out it would be greatly appreciated!

hoping to make something similar to the Akra megaphone design.

cheers,

Scotty.
 
1 - 1 of 1 Posts
Top